Micrófono para directos Royer R-121 Live

The R-121 Live is a ruggedized version of our popular R-121 ribbon microphone. The studio R-121 is tough and has been used on the road for years, but the increased durability of the R-121 Live gives FOH engineers greater confidence in the ribbon standing up to the rigors of the road.

The R-121 Live's output level is comparable to a dynamic mic, and it delivers the warm, realistic tone that only a ribbon mic can. Along with its smooth, natural response, the R-121 Live virtually eliminates the shrill high-end often associated with live guitars and brass. Push up the faders and there's the instrument in all its fullness and natural glory, minus the peaky highs that FOH and Monitor engineers spend so much of their careers fighting.

The R-121 Live is visually differentiated by its red logo. The ribbon element thickness is increased from 2.5 microns to 4-microns, giving the microphone greater durability and a slightly reduced high end response. Highs are often rolled off in live performances, but due to the R-121 Live's exceptionally smooth high frequency response, it needs far less eq'ing than is usually required with condenser and dynamic microphones.

The R-121 Live is backed with Royer's lifetime warranty to the original owner, and the first re-ribbon is free. We expect it to work as hard as you do, so we stand behind it the whole way. As with any high end microphone, proper storage during transit and careful handling during setup and breakdown is key to keeping the microphone in good working order.

  • High SPL Capabilities
  • No internal active electronics to overload or produce distortion up to maximum SPL rating
  • Extremely low residual noise
  • Ribbon element is not affected by heat or humidity
  • Absence of high frequency phase distortion
  • Equal sensitivity from front or back of element
  • Consistent frequency response regardless of distance
  • Electric Guitar Amps
  • Brass Instruments
  • Horn Sections
  • Percussion Instruments
  • Acoustic Operating Principle: Electrodynamic pressure gradient
  • Generating Element: 4-micron aluminum ribbon
  • Magnets: Rare Earth Neodymium
  • Frequency Response: 30 -15,000 Hz +/- 3dB
  • Sensitivity: -50 dBv Re. 1v/pa
  • Output Impedance: 300 Ohms @ 1K (nominal)
  • Rated Load Impedance: >1500 Ohms @ 300 Ohms
  • Maximum SPL: >135dB @ 20 Hz
  • Output Connector: Male XLR 3 pin (Pin 2 Hot)
  • Dimensions: 58mm L, 25mm W (6.13" L, 1" W)
  • Weight: 244g (8.6 oz)
  • Finish: Dull Satin Nickel/Matte Black Chrome optional

Polar Pattern:

Frequency Response: