Micrófono para directos Royer R-122 Live

The R-122 Live is a road-optimized version of our phantom powered R-122 ribbon microphone. The R-122 Live's output is on par with phantom powered condenser mics and it produces the warm, realistic sounds that only ribbon mics can deliver. Along with its smooth, natural response, the R-122 Live virtually eliminates the shrill high-end often encountered with live guitars, brass and drum cymbals. Push up the faders and there's the instrument in all its fullness, minus the peaky highs that FOH and Monitor engineers spend so much of their careers fighting.

The R-122 Live contains a fully balanced, discrete head amplifier system utilizing a specially wound toroidal transformer and ultra-low noise FET's. This system is extremely quiet, can handle 135 dB SPL, and brings the R-122's sensitivity to -37 dB. The R-122 Live can be used on extremely long cable runs with minimal RF interference and signal loss, and the ribbon element cannot be damaged by phantom power, miswired cables or electrical glitches.

The R-122 Live is visually differentiated by its red logo. The ribbon element thickness is increased from 2.5-microns to 4-microns, giving the microphone greater durability and a slightly reduced high end response. Highs are often rolled off in live performances, but due to the R-122 Live's exceptionally smooth high frequency response, it needs far less eq'ing than is usually required with condenser and dynamic microphones.

The R-122 Live is backed with Royer's lifetime warranty to the original owner, and the first re-ribbon is free. We expect it to work as hard as you do, so we stand behind it the whole way. As with any high end microphone, proper storage during transit and careful handling during setup and breakdown is key to keeping the microphone in good working order.

  • Phantom powered circuitry provides high output and impedance matching
  • High SPL Capabilities
  • No distortion up to maximum SPL rating
  • Extremely low residual noise
  • Ribbon element is not affected by heat or humidity
  • Absence of high frequency phase distortion
  • Equal sensitivity from front or back of element
  • Consistent frequency response regardless of distance
  • Rear side of mic records slightly brighter when three feet or closer to sound source
  • Drum Overheads
  • Percussion Instruments
  • Electric Guitar
  • Acoustic Guitar
  • Solo Brass
  • Horn Sections
  • Solo Saxophone
  • Acoustic Operating Principle: Electrodynamic pressure gradient with active electronics
  • Generating Element: 4-micron aluminum ribbon
  • Magnets: Rare Earth Neodymium
  • Frequency Response: 30 -15,000 Hz +/- 3dB
  • Sensitivity: -37 dB (referenced 1v/pa +/- 2dB)
  • Self-Noise: < 20 dB
  • Output Impedance: 200 Ohms, balanced
  • Rated Load Impedance: 1K-Ohm
  • Maximum SPL: >135dB
  • Output Connector: Male XLR 3 pin (Pin 2 Hot).
  • Dimensions: 206mm L X 25mm W (8 1/8" L X 1" W)
  • Weight: 309 grams (10.9 oz)
  • Finish: Dull Satin Nickel/Matte Black Chrome optional.

Polar Pattern:

Frequency Response: